Fabric sanding belt 685 x 50 mm - K 100 (10 pieces)

Cloth belts are more flexible, tear-resistant, and tolerant of bending — suitable for curved surfaces, edges, pipes, and metalworking. Paper belts are more rigid and suitable for flat wood and plastic surfaces. For metal, cloth is always preferable: it withstands heat generated by friction better and does not tear with metal shavings.

100 grit is suitable for sanding metals and hard woods: surface preparation for finishing, blending welded edges. Typical materials: steel, stainless steel, aluminum, hard solid wood. For stainless steel, use specific belts not contaminated by steel — ferrous residues cause oxidation stains. The electrocorundum (Al₂O₃) abrasive cloth in this series maintains its cutting edge longer than paper abrasive of the same grit.

Yes — fabric roll belts can be cut with sturdy scissors or a utility knife. The length from the roll (50 m) allows for belts of any length to be made. Always cut perpendicular to the belt's direction of travel to prevent edge detachment during use.

Aluminum: use belts with a semi-open coat (marked "semi-open coat") and, if possible, apply paraffin wax to the belt to reduce aluminum adhesion. Plastic: reduce speed and work intermittently to avoid overheating the material. A clogged belt does not abrade but only generates heat — it should be cleaned with a wire brush or replaced.

Original spare parts available with 3–5 working day shipping. Customer support in Italian available.